UltraBan PRO
Instructions For Use
Attic:
Multiply the base square footage of the home by 1.5
Estimating Materials
Approximate coverage of 400 square feet per gallon.
As packaged (5 gallons) 2000 square feet
With added Borate and water (7 gallons) 2800 square feet
Crawlspace:
Multiply the base square footage of the crawlspace by 2.
Material Preparation
-
Blend UltraBan PRO before each use.
While mixing UltraBan PRO, add 1 gallon of liquid borate. You must add borate under agitation to prevent shocking.
Partially fil empty borate bottle with warm water, shake vigorously to remove borate residue. Add more water to fill rinsed bottle to one gallon volume and add to pail while under agitation.
Optional: You may add 2-3 ounces of ProFoam Platinum per gallon for foaming application. (Add last)
Mix for 3 more minutes until thoroughly incorporated into a smooth blend.
Blend when pail has set for mor than 1 hours of blending.
-
Remove pump and inline filters to prevent clogging.
Remove lid from PRO and begin blending product with drill mixer.
Optional: Add 1 gallon of liquid borate (see above section for proper blending.)
Filter contents with included strainer when pouring product into pump.
Follow pump operation instructions.
-
Remove lid from UltraBan PRO.
Secure included Gamma Seal lid to pail and unscrew top.
Blend product with drill mixer.
Optional: add 1 gallon of liquid borate (see above section for proper blending).
Screw pump assembly onto pail.
Included strainer may be used to prevent clogs. Cover the pickup tube of the sprayer or filter the contents prior to spraying.
Connect hose and spray wand assembly.
Follow pump operating instructions.
UltraBan PRO Spray Application
Remove or cover stored items in area.
2. Clean visibly dirty areas with a mixture of UltraMean2. Surface discoloration may remain if not removed before the application of UltraBan PRO.
3. Apply UltraBan PRO to all surface areas (wood, concrete) until saturation. PRO’s dried film will provide protection on the surfaces where it is present.
4. Thoroughly clean equipment, tools and containers with soap and water.
Applying to dry surfaces is recommended.
Air and surface temperature must be above 40°F.
Do not apply if risk of wash-off exists prior to drying (typically 30 min - 2 hours, same rate as water).
Storage
Do not allow UltraBan PRO to freeze.
Keep out of direct sunlight.